If the direct write can not be used due to a lack of sparse file support, a large article cache must be configured for the best performance. Most modern filesystems (including NTFS on Windows and EXT3, EXT4 on Linux) support it, with a notable exception being HFS+ on Mac. However, this works only if the destination file with the required size can be created upfront, which requires the support of sparse files. When the option DirectWrite is active, the program writes each article directly into the destination file to the location where the article belongs to. Install Sabnzbd Plugin OpenMediaVault to use with your usenet downloading and NZBGet, CouchPotato, SickRage, SABnzbd and Transmission. NZBGet uses a special technique to avoid the creation of temporary files completely. The latter would drastically decrease the performance because the written temporary files need to be read again and written into the destination file. The downloaded articles are saved to memory (if the article cache is active) or to temporary files. ![]() ![]() To combine the articles into the destination file, the downloaded articles must be saved temporarily until all articles for the file are downloaded. One rar-file may consist of hundreds of articles. Thanks again for everything that you put together.The files are posted to Usenet within articles. Will wait to see if you respond back, and if so, I'll get to it! If you're still around, I'll happily provide the output error I get after getting everything as far as I did. However, I really would like to get this going but just don't have the knowledge to do it. I was REALLY looking forward to this working, but after multiple hours of trial and error, I just gave up :-( The error was something about the TUN not being available. AFter adding all those folders, I found that I kept getting another error when trying to start up the stack. I had about 6 different folders that just didn't exist and kept the stack from launching. I followed the guide to the T, but when I went to stand up the stack, I found that the directories you had us make in the guide were DEF not the same that were being requested by the YAML file. I wanted to point out that there are a LOT of changes from this guide and the available yaml and ENV files on your Github. Good luck You are Amazing for this setup!! Thank you soo much ahead of time. In this case you should set option to the default value 'nzbget' or use empty value.![]() You can then change all of the ports in the ENV file, so none of them conflict with anything which is currently running on your Synology. for older NZBGet versions may not have an option to define user name. ![]() You can check active ports on Synology by running: sudo netstat -tulpn If you continue to have issues with ports, it may be some of the ports numbers are already active on your system. The ENV file has changed slightly, there are only two folders, one for Docker configurations (use /volume1/docker) and one to contain all the media / downloads (use /volume1/data) or something similar. Then follow the README in the top link (individual-apps) and install them one at a time - Gluetun MUST be first. Then you can extract all of the files from the "individual-apps" folder. then selecting " Code" -> "Download Zip". You can download all of the YAML files in the "Individual-app" directory, by going to GitHub - geekau/media-stack: Docker-Compose files and configs to build your desired media stack, quickly and easily.
0 Comments
Leave a Reply. |